What to do if the front furrow width changes while working with LEMKEN Juwel 8?
If the front furrow width changes during operation, it's likely due to a leaking piston seal on the frame swivelling cylinder. The suggested solution is to replace the piston seal.
Why won't my LEMKEN Farm Equipment plough start to turn?
If the plough does not start to turn, it is likely that the power supply is disconnected. Restore the power supply to resolve this issue.
Covers liability, guarantee, copyright, and optional accessories.
Outlines general safety rules, target groups, and intended device use.
Details the implement's components, structure, and key parts.
Steps for preparing the tractor before attaching the implement.
Procedures for setting up the implement before initial use.
Instructions for rotating the plough frame 180 degrees.
Adjusting the front furrow width mechanically and hydraulically.
Methods for setting and adjusting the working depth of the implement.
Explains the operation modes for on-land ploughing.
Covers safety, intervals, and procedures for upkeep and fixing issues.
Identifies common faults and their remedies for plough performance.
Provides specifications, model details, weight, and type plate information.
General| Type | Mounted Reversible Plough |
|---|---|
| Number of Furrows | 3-7 |
| Frame Type | Modular |
| Turnover Axle | Hydraulic |
| Linkage | Three-point linkage |
| Material | Steel |
| Furrow Width | 40 cm |
| Working Depth | Up to 30 cm |
| Tractor Power | 90-300 HP |
To Next Page