LEMKEN Juwel 8 - Working Width for each Base; Juwel V

Operation
64
11.10 Working width for each base
11.10.1 Juwel V
2 - 4 furrows
Above 5 furrows
Once the basic plough settings have been
made with the OPTIQUICK adjusting cen-
tre, the working width for each base can be
changed as required from the tractor seat
using the working width adjusting cylinder
(1).
 Smaller working width => Extend piston
rod (2)
 Larger working width => Retract piston
rod (2)
The set working width is indicated on the
scale (3).
2
3
1
1