LEMKEN Juwel 8 - DURAL Plough Body; Contact Angle

Operation
62
11.9 DURAL plough body
11.9.1 Contact angle
The clearance between the share tips and
the plough frame should be the same for
all plough bodies. The dimension D should
be approx. 1.5 cm. The necessary adjust-
ment is made with the adjusting screw (1).
 Loosen the body screw (2) and the
clamping screw (3).
The bodies are mounted with the contact
angle central to the ground. The contact
angle can be changed with the adjusting
screw (1) if required.

Adjust the adjusting screw (1).
 Larger contact angle, notch (4) =>
better heeling.
 Smaller contact angle, (5) => better
depth guidance.
 Then re-tighten all the screws.
See «Tightening torques, page 101».
1
3
A
1
2
D
1
4
5