Operation
74
11.17 Depth Control Wheel and Depth and Transport Wheel
11.17.1 General Instructions
The plough is available with depth control
wheel (1) or depth and transport wheel.
The depth and transport wheel is required
when the front axle - especially for
transport - is unloaded too much and so
the steerability of the tractor is no more
ensured.
The depth control wheel (1) respectively
the depth and transport wheel should work
as control wheel, only.
The tractor hydraulics must be adjusted in accordance to that.
To prevent that the working depth of the plough with Non-Stop overload safety
device (T-version) increases after tripping, the depth wheel should be loaded with
more weight of the plough.
11.17.2 Moving the hydraulic Uni wheel from the working position to the
transport position
CAUTION
Read and follow «Safety measures and precautions, page 13»
and «Hazard caused by hydraulic systems, page 20».
There are crushing and shearing points in the area around the
wheel stops
Keep a safe distance away.
Do not exceed the maximum permissible tyre pressure.
1
To Next Page
Loading...
