LEMKEN Juwel 8 - Setting the Front Furrow Width

Operation
55
The inclination is set separately for each side of the plough. The
inclination setting may be different for the right-hand and left-hand
sides of the plough.
11.4 Setting the front furrow width
11.4.1 General information
The front furrow width must be set to correspond to the working width of the fol-
lowing plough base with the Optiquick setting system.
11.4.2 Front furrow width, mechanical

Front furrow too narrow
 Turn the outer spindle (1) for longer
 Front furrow too wide
 Turn the outer spindle (1) for a shorter
time