EasyManuals Logo

Lennox 16HPX-048 Installation Instructions

Lennox 16HPX-048
18 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
©2019 Lennox Industries Inc.
Dallas, Texas, USA
Page 1
THIS MANUAL MUST BE LEFT WITH THE
HOMEOWNER FOR FUTURE REFERENCE
WARNING
Improper installation, adjustment, alteration, service
or maintenance can cause property damage, personal
injury or loss of life. Installation and service must be
performed by a licensed professional HVAC installer or
equivalent, or service agency.
IMPORTANT
The Clean Air Act of 1990 bans the intentional venting of
refrigerant (CFCs, HCFCs and HFCs) as of July 1, 1992.
Approved methods of recovery, recycling or reclaiming
must be followed. Fines and/or incarceration may be
levied for noncompliance.
INSTALLATION
INSTRUCTIONS
HEAT PUMP
507876-01
8/2019
Merit
®
Series 16HPX Units
General
This 16HPX outdoor heat pump is designed for use with
HFC-410A refrigerant only. This unit must be installed with
an approved indoor air handler or coil. For AHRI Certied
system match-ups and expanded ratings, visit www.Len-
noxPros.com. These instructions are intended as a gen-
eral guide and do not supersede local codes in any way.
Consult authorities having jurisdiction before installation.
NOTICE!
Charging information is given on the charging
procedure sticker on the unit access panel. For
more in-depth information, consult the Installation
and Service Procedures manual on LennoxPros.
com or through the Technical Support department
at 800-453-6669.
CAUTION
As with any mechanical equipment, contact with sharp
sheet metal edges can result in personal injury. Take
care while handling this equipment and wear gloves and
protective clothing.
NOTES -
Service clearance of 30 in. (762 mm) must be maintained on one of
the sides adjacent to the control box.
Clearance to one of the other three sides must be 36 in. (914 mm).
Clearance to one of the remaining two sides may be 12 in. (305
mm) and the final side may be 6 in. (152 mm).
A clearance of 24 in. must be maintained between two units.
48 in. (1219 mm) clearance required on top of unit.
See
NOTES
See NOTES
See NOTES
See
NOTES
CONTROL
BOX
STEP 1 – SETTING THE UNIT – Clearances

Other manuals for Lennox 16HPX-048

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lennox 16HPX-048 and is the answer not in the manual?

Lennox 16HPX-048 Specifications

General IconGeneral
BrandLennox
Model16HPX-048
CategoryHeat Pump
LanguageEnglish

Related product manuals