17
Screen Lock
There are three options for screen locking. Default is unlocked.
• Unlocked - Changes can be made to any settings.
• Partially Unlocked - Screen is locked but temperature settings can be
changed.
• Locked - No changes can be made.
To unlock partially locked or locked, press anywhere on the screen and hold
for ve seconds.
Date & Time
The following items can be set on this screen:
1. The clock can be changed to 24 hour (military). Default is OFF.
2. The following settings are only available if the system is not connected to
the Internet.
• Daylight Savings - ON or OFF. Default is ON.
• Time Zone: Options are Pacic, Mountain, Central and Eastern.
Default is Central. Select time zone and press SET.
• Set Time - Local time can be adjusted. Press SET to nish.
• Set Date - Current date can be set. Press SET to nish.
NOTE: If the system is connected to the Internet, only changing to the 24 hour
clock is available. To change either time zone or daylight Savings,
temporarily disable Wi-Fi to make adjustments to those settings.
Language
This allows the language used on the screen to be changed. Options are
English, Français and Español. Default is English.
Display
The following setting options available are:
1. Outdoor Weather - Turn ON to display weather on the HOME screen.
2. Outdoor Temperature Display - Options are:
• Internet (AccuWeather) - Will display weather provided by
AccuWeather for the local area based on the homeowner zip code.
NOTE: Thermostat has to be connected to the Internet, system is registered,
and you are logged into www.lennoxicomfort.com for this feature to
work. See menu > system settings > account to verify.
• Sensor - Display outdoor temperature only from installed remote
outdoor sensor.
3. Outdoor Air Quality - Turn ON to display outdoor air quality on the
weather screen.
4. Indoor Humidity - Turn ON to display indoor humidity above the indoor
temperature on the HOME screen.
5. Proximity Sensor - When turned ON, the display will wake up automatically
upon approach.
6. Screen Saver - Options for this feature are:
NOTE: For weather or screen saver photo (upload) to work, the thermostat has
to be connected to the Internet, system registered, and the thermostat
is logged into your Lennox account. See menu > system settings >
account to verify. Screen saver will appear approximately 30 seconds
after no screen interaction.
• Off
• Weather - If turned on, will allow up to 26 animated weather screen
savers based on the AccuWeather outdoor weather forecast for the
local zip code.
• Power Save - Screen is blank until the screen is touched or activated
by proximity sensor if enabled.
• Photo
» Photo Upload
• Logged into either www.lennoxicomfort.com or your Lennox
iComfort mobile app and select your applicable thermostat if
more than one exists. Select the menu icon and then select
“upload photo”.
• A photo upload screen will appear that will let you browse for
a photo on your computer or mobile device. Navigate to the
desired photo and select it. Then select Upload.
NOTE: It may take a few minutes depending of the photo size to
upload to your thermostat. The following are approximate
upload times, depending on your Internet access speeds,
times may vary.
Table 4. Approximate Picture Upload Time
File Size Upload Duration
1.59MB 1:25 minutes
2.05MB 1:49 minutes
2.77MB 1.51 minutes
5.91MB 2.24 minutes
NOTE: Picture requirements:
To Next Page
Loading...
Need help?
General
