Page 86 MUL41E-0610/06-2011
• Alarm 241: Immediate shut down of the circuit 2. The alarm is signalling,
• Alarm 242: Immediate shut down of the circuit 2. The alarm is signalling,
• Alarm 243: Immediate shut down of the circuit 2. The alarm is signalling,
• Alarm 244: Immediate shut down of the circuit 2. The alarm is signalling,
• Alarm 245: Immediate shut down of the circuit 2. The alarm is signalling,
• Alarm 246: Immediate shut down of the circuit 2. The alarm is signalling,
• Alarm 248: Immediate shut down of the circuit 2. The alarm is signalling,
• Alarm 249: Immediate shut down of the circuit 2. The alarm is signalling,
Reset
Once the data read is coherent for 2 minutes, the alarm is automatically deleted. Up to 3 trips can occur during a
day and are saved in the alarm historic. The two first trips don’t give the alarm alert except if a trip is still present
during 1 hour, and are automatically reset every day at 6h00 am. The third trip activates the fault report and must
be manually reset.
Possible cause(s)
• Problem with wiring connection,
• Probe or sensor damaged.
Remedies
• Check the wiring connections,
• Replace the probe or sensor.
To Next Page
Loading...
