IOM / ROOF-TOP FLEXY™ Series - Page 95
Confirm by clicking on «Submit»
PROBLEM SOLVING
Impossible to enter your access code, you remain
on the welcome page.
Local communication has been interrupted. You must restart
the local unit.
After restarting, you must wait for 5 to 10 minutes until the unit
is ready to be queried once more.
The values read do not seem to move.
The values are not in fact refreshed automatically, and for all
the pages you must use the Refresh function to be sure you
are reading the latest values.
The keyboard has disappeared from the task bar.
Click on Start / Programs / StartUp
The local unit is not answering the phone.
The local unit is - or was - powered down, and you must press
the On/off button.
See recommendations at the beginning of the document.
The unit is not connected to a direct analogue phone line.
How to check the ClimaLink is functioning correctly after
installation :
Connect up the unit and the KP14
Connect the cables to the J18 inputs on the Climatic boards.
After a few minutes, the central unit should start its dialogue.
The LED on the Climatic board to the right of the J18 input
should flash.
If this does not happen, check the wiring.
The only way to examine the problem in more detail is to obtain
a monitor and a mouse and contact the Lennox services.
After installing a ClimaLook or ClimaLink central unit, it is vital
to perform the telephone communication tests.
Take a test telephone set and make sure you have a
connection.
Note the telephone number to which the central unit is
connected.
Connect the central unit and ask a person on the remote site
to test communication.
Obviously the central unit must be the only device installed
on the phone line. It cannot share the line with a fax or another
modem.
Reposition the keyboard in the task bar by clicking on the
minus sign in the top right-hand part of the keyboard.
control interface CLIMALINK / CLIMALOOK
To Next Page
Loading...