Server model with two 2.5-inch hot-swap rear drive bays and one PCIe slot
The following illustration shows the rear view of the server model with two hot-swap drive bays and one PCIe
slot. Depending on the model, your server might look slightly different from the illustration below.
Table 7. Components on the rear of the server
1 Ethernet connectors on OCP 3.0 Ethernet adapter
2 Network management interface
3 USB 3.0 connector 4 VGA connector
5 NMI button 6 Power supply 1
7 Power supply 0 8 Rear 2.5-inch drive bays
9 PCIe slot 1
Note: For more information about each component, see “Rear components overview” on page 16.
Chapter 2. Server components 15
To Next Page
Loading...
