Lenovo ThinkSystem HR350A - Page 29

29
4. Remove the riser assembly. See "2.2.7 Riser module replacement".
5. Press the tab (Step1) to pivot the card latch to the open position (Step 2) on the PCIe cage module.
6. Pull the PCIe card outwards to remove it. (Step 3).
Removing PCIe card
To remove a riser card, do the following:
1. Lift the PCIe cage module from chassis.
2. Use a screwdriver to release the screws on the PCIe cage (step1).
3. Pull out the riser card (step 2).
To reinstall, reverse the steps above.
Special Note: Refer to the table below for the specifications and the assigned slots for PCIe cards supported by HR350A.
Slot no.
Supported size
Slot specifications
Remark
1
Full-height,
half-length
×8
2
Full-height,
half-length
×8
3
Full-height,
half-length
×8
4
Half-height,
half-length
Not support
5
Full-height,
half-length
×8
6
Full-height,
half-length
Not support