32
2.2.11 Hot-swap drive replacement
Do not proceed before reading and understanding the "Safety Precautions" section of this chapter and "Read Me First".
Note: The diagrams below are only for servers with 2.5-inch hard drive configuration.
To remove a 2.5-inch hot-swap drive, do the following:
1. Gently push the release latch of the hot-swap drive to open the handle of the drive.
Pushing the release latch of a 2.5-inch hot-swap drive
2. Pull the handle to slide the drive out of the chassis.
Removing a 2.5-inch hot-swap drive
To reinstall, reverse the steps above.
To Next Page
Loading...
