Figure 40. Compute node cover installation
Step 1. Carefully lay the compute node on a flat, static-protective surface, orienting the compute node with
the bezel pointing toward you.
Step 2. Orient the compute node cover so that the posts on the inside of the cover slide into the slots on
the compute node.
Note: Before you close the compute node cover, make sure that the air baffle and all components
are installed and seated correctly and that you have not left loose tools or parts inside the compute
node. Retention clips that secure the I/O expansion adapters must be in the closed position to
install the compute node cover.
Step 3. Hold the front of the compute node and slide the compute node cover forward to the closed
position, until it clicks into place.
1. Install the compute node into the chassis (see
“Install a compute node ” on page 63 for instructions).
Install a compute node
Use this information to install a compute node.
To avoid possible danger, read and follow the following safety information.
Chapter 3. Compute node hardware setup 63
To Next Page
Loading...
