3. After you have Lenovo XClarity Essentials OneCLI in place, type the following command to set the
UUID:
onecli config set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value> [access_method]
Where:
<uuid_value>
Up to 16-byte hexadecimal value assigned by you.
[access_method]
The access method that you select to use from the following methods:
– Online authenticated LAN access, type the command:
[--bmc-username xcc_user_id --bmc-password xcc_password]
Where:
xcc_user_id
The BMC/IMM/XCC account name (1 of 12 accounts). The default value is USERID.
xcc_password
The BMC/IMM/XCC account password (1 of 12 accounts).
Example command is as follows:
onecli config set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value>
--bmc-username xcc_user_id
--bmc-password xcc_password
– Online KCS access (unauthenticated and user restricted):
You do not need to specify a value for access_method when you use this access method.
Example command is as follows:
onecli config set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value>
Note: The KCS access method uses the IPMI/KCS interface, which requires that the IPMI
driver be installed.
– Remote LAN access, type the command:
[−−bmc xcc_user_id:xcc_password@xcc_external_ip]
Where:
xcc_external_ip
The BMC/IMM/XCC external IP address. There is no default value. This parameter is
required.
xcc_user_id
The BMC/IMM/XCC account name (1 of 12 accounts). The default value is USERID.
xcc_password
The BMC/IMM/XCC account password (1 of 12 accounts).
Note: BMC, IMM, or XCC external IP address, account name, and password are all valid for
this command.
Example command is as follows:onecli config set SYSTEM_PROD_DATA.SysInfoUUID <uuid_value>
−−bmc xcc_user_id:xcc_password@xcc_external_ip
4. Restart the Lenovo XClarity Controller.
5. Restart the server.
Chapter 4. System configuration 81
To Next Page
Loading...
