Lenze 8104 - Page 67

Code level
8100_A Technical description
* C112 Preselection:
Freely assignable
digital input
PRG
<===>
Parameter level
Factory
I
Customer
settings settings
-1-
1 1-----------
Select the desired input using C112, then 8ss;g"
the tL01Ction under C113, and the polarity under
C115.
---------------------------------------------------------
-1- SH + PRG digital input te inal EI
---------------------------------------------------------
-2- SH + PRG digital input te inal E2
---------------------------------------------------------
....
------------------------------------------------.-.------
-5- SH + PRG digital input te inal ES
-----------------------------------.--.------------------
Change is only possible when controller inhibited
* C113 :~~~O::ssignable
I
.:~:--~~_:-~~~---~-~~~~~-- __
I
te~:E1
digital input -,- SH + PRG Enable of additional Ti times
tor [C112J term. E2
-2- SH + PRG Enable tor JOGset-values -3-
---------------------------------------------------------
-3- SH + PRG TRIP Reset
---------------------------------------------------------
-4- SH + PRG TRIP Set
-------------------------------------------.-------------
-5- SH + PRG Enable ot DC brake
-----------------------------------------------------.---
-7- SH + PRG I-ccq>onent =zero
---------------------------------------------------------
-9- SH+ PRG R , tL01Ctiongenerator stop
---------------------------------------------------_.----
-10 SH+ PRG R , tL01Ctiongenerator input =0
-------------------_._-----------------------------------
-13 SH + PRG Enable process control
-----------------------------------------_.....---.-.....
-20 SH+ PRG Select par_ter set
.................._......_.....................-.--......
-21 SH + PRG Load par_ter set
----...-..------------------.....--.--..--..--..--...--..
Change 15 only possible when controller inhibited
1 1 1______._.__
. C114 Polarity
freely assignable
digital input
tor [C112J
_:~:__~~_:_~~~___~~~_~~~~_~~~~~~ Ite~: EI
-1- SH + PRG Input LOI/ active
--~~~;.;~-;,;;i;-~~~i~i~-~~-~;,;;;~~ii~~-i~i~i;~;I te~: E2
te E3
-0-
term. E4
-0-
1-.-----.----.--...--.---.--__.___.___________.___________.
.C115 ~~~~~~t~ssi gnable
I
_:~:--~~-:-~~~--- ~~~-~- ~~~~~~~-~~~-~~~-~~~- ___
digital input -1- SH+ PRG camot be switched off via COOl
tor [C112J
lenze
.--------------.-------..-------.---.---..---.---.---.-..
Change is only possible when controller inhibitedl
--------..--------------..---.------.---..------------.---
The control codes of priority signals should not
be changed via the operating unit 810288 or the
lECCItinterfacee, because the terminal signal
will overwrite these settings.
65
term. E3
-S-
teno. E4
-2-
te..... ES
-2-
te..... ES
-0-
---------1-----------
te..... EI
-1-
term. E2
-1-
te..... E3
-0-
tenn. E4
-0-
term. ES
-0-