Lenze
3-11
8200 motec/starttec en 12/03
3
Global Drive Control – GDC easy parameter setting software
The Global Drive Control parameter setting software
incorporates all of the functions described here. If you
wish only to set parameters for the frequency inverter,
you can use Global Drive Control easy:
System requirements of GDC (easy)
Hardware:
• IBM-AT or compatible PC
• CPU
– Pentium 90 or higher
• RAM
– 64 MB
• At least 120 MB free hard disk space
• Super VGA graphics card
• CD-ROM drive
• One free serial interface for RS232 or one free
parallel interface for system bus adapter (CAN)
Software:
– Windows 95/98/Me/NT 4.0/2000/XP
Feature GDC easy GDC
Short setup:
starttec ✓✓
8200 ✓✓
8200 vector/motec ✓✓
9300 vector ✓
9300 Servo ✓
Technology functions
1)
✓
Code lists ✓✓
Monitor window ✓✓
Function block editor ✓
Oscilloscope functions
2)
✓
Order number: ESP-GDC2-E ESP-GDC2
1)
For 9300 Servo drives
2)
For 9300 drives
To Next Page
Loading...
