Standard controllers
starttec – Overview
Lenze
2-21
8200 motec/starttec en 12/03
2
Standard functions
• Configurable starting/stopping ramps 0...3.0 s
logic operations (AND, OR, XOR, NOT) can be applied to
input signals
• Jog (start command with time base)
• Elapsed time meter
• Configurable current threshold
• Digital outputs with configurable delay
Protection functions
• Input for motor PTC or thermal contact
• I
2
t monitoring for motor protection
• Configurable current limiting
• Warnings and error messages in the event of
overcurrents
• Warnings and error messages in the event of motor
starter overtemperatures
• Mains and mains phase failure detection
Operation and control
• Integrated controls (potentiometer) for setting the nominal
motor current/starting and stopping ramps
• Keypad
• Copy function with Keypad for transferring starter
settings
• Password protection
• Control and parameter setting software “Global Drive
Control easy” (downloadable from the Internet)
Power range
0.25 kW...4.0 kW 110 V-500 V (+/-10%)
• Optional change of direction of rotation/multi-motor
mode
• Electronic circuit-breaker
Fieldbus communication
• RS232 serial interfaces
• Bus interface to most common fieldbus systems (CAN,
PROFIBUS-DP, INTERBUS)
• AS-Interface integrated into the standard controller as an
option
Input and output terminals
• 5 digital inputs with switchable logic
(freely configurable)
• 4 digital outputs (freely configurable)
Braking
• 1 output for direct control of spring-loaded brakes with
configurable delay
Control
• Via digital I/O and/or
• Via fieldbuses
To Next Page
Loading...
