X3.2/ Designation Function Level
7 GND Reference potential for X3.2/20
39 Reference potential for controller inhibit (CINH) on X3.2/28
28 CINH Controller inhibit • Start = HIGH (+12 V ... +30 V)
• Stop = LOW (0 … +3 V)
20 DC voltage source for internal controller inhibit +20 V (reference: GND)
(CINH) power supply
3
Lenze
3-28
8200 motec/starttec en 12/03
Automation
Fieldbus function modules
AS-interface
X3.1/ Wire colour Function
(IEC 757)
+ BN (brown) Please refer to the information included in the description of the AS-i system about
- BU (blue)
the electrical connection of peripheral devices.
The AS-interface fieldbus function module enables the
8200 motec to be controlled with digital control signals via
the "AS-interface" bus system. This function is featured in the
starttec as an option. The "AS-interface" (AS-i) bus system
has established itself for use at the lowest field level,
particularly for digital signal transfer.
It is designed for applications that do not necessarily
require powerful fieldbus systems, but do nonetheless
need to exploit the advantages of serial communication.
Terminal assignment for the E82ZAFL001 function module
The advantages of this system are:
• Easy to use and to set up
• Less wiring required
• Easy to integrate into existing systems
• Cost reductions
AS-interface – can be used in the 8200 motec Order no. E82ZAFFC001
The option for control via AS-interface is integrated Order no. E71MM402F4A010
into the following starttec products as standard.
Order no. E71MM402F2A010
Order no. E71MM402F4A020
Order no. E71MM402F2A020
Controller inhibit (CINH) power supply
Supply via internal voltage source (X3.2/20):
Minimum wiring required for operation
Controller inhibit (CINH) power supply
via external voltage source
To Next Page
Loading...
