Lenze 930 Series

Contentsi

36
MA 13.0001 DE-EN DE/EN 2.0
1 Safety instructions 37.................................................
1.1 General safety and application notes for Lenze controllers 37..........
1.2 Residual hazards 40............................................
1.3 Definition of notes used 41......................................
2 Technical data 42.....................................................
2.1 General data and operating conditions 42..........................
2.2 Rated data 43.................................................
3 Mechanical installation 44.............................................
3.1 Important notes 44.............................................
3.2 Dimensions 45.................................................
3.3 Mounting clearance 46..........................................
4 Electrical installation 47...............................................
4.1 Important notes 47.............................................
4.2 Installation according to EMC (installation of a CE-typical
drive system) 48...............................................
4.3 Voltage supply 50..............................................
4.4 Motor connection 51...........................................
4.5 Control terminals 52............................................
4.6 Feedback connection 53.........................................
4.6.1 Resolver at X7 53.....................................
4.6.2 SinCos encoder at X8 54................................
4.7 Communication 55.............................................
4.7.1 Connection of digital frequency coupling at X10 55.........
4.7.2 Connection of CAN bus 56..............................
4.7.3 Connection of PROFIBUS 57.............................
5Finalworks 58.......................................................
5.1 Before switching on 58.........................................
5.2 Initial switch-on 59.............................................