Parameter setting
Parameter setting with the XT EMZ9371BC keypad
Diagnostics
2
21
EDKVF93−05 EN 1.0
2.1.8 Diagnostics
The two submenus "Actual info" and "History" in the "Diagnostic" menu contain all codes
for the
ƒ monitoring of the drive
ƒ error diagnosis
Status messages are additionally displayed in the operating level. If several status
messages are active, the message with the highest priority is displayed:
Priority Display Meaning
1 GLOBAL DRIVE INIT Initialisation or communication error between
keypad and controller
2 XXX − TRIP Active TRIP (contents of C0168/1)
3 XXX − MESSAGE Active message (contents of C0168/1)
4
Special device states:
Switch−on inhibit
5
Source for controller inhibit (the value of C0004 is displayed simultaneously):
STP1
9300 Servo: Terminal X5/28
ECSxS/P/M/A: Terminal X6/SI1
STP3 Operating module or LECOM A/B/LI
STP4 INTERBUS or PROFIBUS−DP
STP5
9300 Servo, ECSxA: System bus (CAN)
ECSxS/P/M: Motion bus (CAN)
STP6 C0040
6
Source for quick stop (QSP):
QSP−term−Ext MCTRL−QSP input of the MCTRL function block is applied to HIGH signal
QSP−C0135 Operating module or LECOM A/B/LI
QSP−AIF INTERBUS or PROFIBUS−DP
QSP−CAN
9300 Servo, ECSxA: System bus (CAN)
ECSxS/P/M: Motion bus (CAN)
7 XXX − WARNING Active warning (contents of C0168/1)
8 xxxx Value under C0004
efesotomasyon.com - Lenze
To Next Page
Loading...
