Troubleshooting and fault elimination
Resetting error messages
Fault messages on the keypad or in the parameter setting program Global Drive Control
3
38
EDKVF93−05 EN 1.0
3.5 Resetting error messages
Eliminate the cause of TRIP fault message
After you have eliminated the cause of a TRIP fault message, you must reset the fault
message with the command "TRIP reset". Only then the drive restarts.
Note!
A TRIP fault message can have several causes. Only if all causes of the TRIP
have been eliminated, the TRIP reset can be executed.
TRIP reset
ƒ Keypad XT: Press $. Then press % to enable the controller.
ƒ Fieldbus module: Set C0043 = 0
ƒ Control word: C0135
ƒ Terminal: X5/E5 = HIGH
ƒ Control word via AIF
ƒ Control word via system bus (CAN)
Mains switching always executes TRIP reset.
Codes for parameter setting
Code Possible settings IMPORTANT
No. Name Lenze Selection
C0043 Trip reset 0
0 no/trip reset Reset actual error
1 trip active There is a TRIP error
efesotomasyon.com - Lenze
To Next Page
Loading...
