Technical data
Features
3
l
19
EDBMB935X EN 8.0
3 Technical data
3.1 Features
ƒ Two designs with identical dimensions
– 9351 brake module with internal brake resistor for frequent braking
with low power or unfrequent braking with medium power
– 9352 brake chopper with external brake resistor for higher peak braking
power and continuous braking power
ƒ Conversion of the mechanical braking energy into heat energy
– During braking operation, the controller does not set pulse inhibit
unintentionally, i.e. braking operation remains controlled
ƒ Very short braking times can be reached
ƒ Enclosure IP20 for installation within the control cabinet
ƒ DIN rail mounting
ƒ Separable heatsink
– Cooling outside of the control cabinet can be realised
ƒ Switching threshold for the mains voltages 230 V, 400...460 V and 480 V
can be set via internal switches
ƒ Parallel operation of several braking units possible
– Synchronisation via built−in interface
ƒ Status display via LEDs
ƒ Braking units are not short−circuit−proof
To Next Page
Loading...
