Safety instructions
General safety and application notes for Lenze controllers
2
l
12
EDBMB935X EN 8.0
2 Safety instructions
2.1 General safety and application notes for Lenze controllers
(in accordance with Low−Voltage Directive 2006/95/EC)
For your personal safety
Depending on their degree of protection, some parts of the Lenze controllers
(frequency inverters, servo inverters, DC speed controllers) and their accessory
components can be live, moving and rotating during operation. Surfaces can be
hot.
Non−authorised removal of the required cover, inappropriate use, incorrect
installation or operation, creates the risk of severe injury to persons or damage
to material assets.
For more information, please see the documentation.
High amounts of energy are produced in the controller. Therefore it is required
to wear personal protective equipment (body protection, headgear, eye
protection, ear protection, hand guard).
All operations concerning transport, installation, and commissioning as well as
maintenance must be carried out by qualified, skilled personnel (IEC 364 or
CENELEC HD 384 or DIN VDE 0100 and IEC report 664 or DIN VDE 0110 and
national regulations for the prevention of accidents must be observed).
According to this basic safety information, qualified, skilled personnel are
persons who are familiar with the assembly, installation, commissioning, and
operation of the product and who have the qualifications necessary for their
occupation.
To Next Page
Loading...
