Mechanical installation
Mounting steps
5
49
EDK94AZMP DE/EN/FR/ES/IT 8.0
5.4 Mounting steps
Use with 9400
Proceed as follows for the installation:
1. Prepare M5 threaded holes on the mounting plate, for instance according
to the mounting grid.
– Always use all mounting points specified.
2. Screw the filter onto the mounting plate.
– Use M5 screw and washer assemblies or M5 hexagon socket screws
with washers.
– If further devices are to be mounted directly adjacent on the right−hand
side of the filter, do not tighten the screws fully before all devices are
mounted and aligned.
– Tightening torque: 3.4 Nm (30 lb−in).
Use with i700
How to proceed during mounting:
1. Prepare M5 threaded holes on the mounting plate.
– Always use all fixing points specified.
2. Screw the filter to the mounting plate.
– Use M5 screw and washer assemblies or M5 hexagon socket screws
with washers.
– Tightening torque: 3.4 Nm (30 lb−in).
To Next Page
Loading...
