EasyManuals Logo

Lenze ECSEM Series Mounting Instructions

Lenze ECSEM Series
Go to English
200 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #73 background imageLoading...
Page #73 background image
Safety instructions
General safety and application notes for Lenze controllers
2
73
EDKCSEX064 DE/EN/FR 6.0
ƒ High amounts of energy are produced in the controller. Therefore it is
required to wear personal protective equipment (body protection,
headgear, eye protection, ear protection, hand guard).
Application as directed
Controllers are components which are designed for installation in electrical
systems or machines. They are not to be used as domestic appliances, but only
for industrial purposes according to EN 61000−3−2.
When controllers are installed into machines, commissioning (i.e. starting of the
operation as directed) is prohibited until it is proven that the machine complies
with the regulations of the EC Directive 2006/42/EC (Machinery Directive);
EN 60204 must be observed.
Commissioning (i.e. starting of the operation as directed) is only allowed when
there is compliance with the EMC Directive (2004/108/EC).
The controllers meet the requirements of the Low−Voltage Directive
2006/95/EC. The harmonised standard EN 61800−5−1 applies to the controllers.
The technical data and supply conditions can be obtained from the nameplate
and the documentation. They must be strictly observed.
Warning: Controllers are products which can be installed in drive systems of
category C2 according to EN 61800−3. These products can cause radio
interferences in residential areas. In this case, special measures can be
necessary.
Transport, storage
Please observe the notes on transport, storage, and appropriate handling.
Observe the climatic conditions according to the technical data.
Installation
The controllers must be installed and cooled according to the instructions given
in the corresponding documentation.
The ambient air must not exceed degree of pollution 2 according to
EN 61800−5−1.
Ensure proper handling and avoid excessive mechanical stress. Do not bend any
components and do not change any insulation distances during transport or
handling. Do not touch any electronic components and contacts.
Controllers contain electrostatic sensitive devices which can easily be damaged
by inappropriate handling. Do not damage or destroy any electrical components
since this might endanger your health!

Table of Contents

Other manuals for Lenze ECSEM Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lenze ECSEM Series and is the answer not in the manual?

Lenze ECSEM Series Specifications

General IconGeneral
BrandLenze
ModelECSEM Series
CategoryControl Unit
LanguageEnglish

Related product manuals