Why signals are not read in at digital inputs (X3) in Lenze DC Drives?
If the signals are not read in at digital inputs (X3) on your Lenze DC Drives, it may be because the HIGH levels of the input signals are too low (less than 13 V). Ensure the HIGH levels of the input signals are between 13 V and 30 V.
Outlines basic safety measures, handling, and requirements for qualified personnel.
Warns about specific dangers like electrostatic discharge and parameter set saving.
Details the correct procedure for wiring the terminal strips, including safety precautions.
Explains the connections and functions of terminal strips located on the top of the Drive PLC.
Describes the connections and functions of terminal strips located on the bottom of the Drive PLC.
Provides essential checks and precautions to take before powering up the system.
Lists common maloperations, their causes, and recommended remedies for troubleshooting.
To Next Page
General
