Lenze EVS9322-ES - Page 185

Appendix
11-66

BA9300SU EN 2.1
I
Informationonoperation, 6-2
Inputs
Analog, 4-21
Digital, 4-21
Installation
CE-typical drive system, 4-34
Assembly, 4-34
Filters, 4-34
Grounding, 4-34
Shielding, 4-34
Cold plate, 4-6
Electrical, 4-9
Mechanical, 4-1
Standard assembly, 4-2
Insulation, 4-10
J
JOG setpoint, 11-19
Jumper, Analog setpoint selection, 4-21
K
Keypad, 7-7
Operating level, 7-9
Status messages, 9-1
Operating level, 7-9
Operating unit
Display, 7-7
Key functions, 7-8
User menu, 7-9
L
Labelling, Controller, 1-2
Leakage inductivity, 11-20
LECOM, Status word C0150, 9-2
Legal regulations, 1-2
Liability, 1-2
M
Mains conditions, 4-12
Mains connection, 4-13
Protection, 4-14
Mains filter, 3-7
Mains types, 4-12
Maintenance, 10-1
Manufacturer, 1-2
Maximum speed, 11-17
Mechanical installation, 4-1
Message, 8-15
Messages, Error, 9-5
Monitor output, 4-21
Monitoring, 8-15
FAIL-QSP, 8-15
Fault display via digital output, 8-18
Message, 8-15
Monitoring functions, 8-17
Reactions, 8-15
Set reactions, 8-16
Warning, 8-15
Motor, Selection list, 11-56
Motor cable, Shielding, 4-15
Motor connection, 4-15, 4-16
Motor potentiometer, 11-27
Motor protection, 4-11
Motor stator resistance, 11-20
N
Noise optimised operation, 11-18
Notes on operation, 6-2
O
Operating mode of the motor control, 11-17
Operation, 6-1
Oscillations, 4-1
Outputs
Analog, 4-21
Digital, 4-21
Overspeeds, 2-2