Multi-axis controllers
Control terminals
5
201
EDS94SPP101 EN 7.1
State bus
The state bus is a bus system exclusively designed for Lenze controllers via which up to 20
controllers can be connected and which serves to simulate a ”release cord” function. The
state is c ontrolled via the system module SFBDigitalOutput.
ƒ The state bus knows the states ”OK” and ”fault”.
ƒ The state bus is multi-master-compliant, i.e. each node connected to the state bus
can set the state bus to ”fault” by changing to LOW level.
ƒ In the ”fault” status, all nodes activate their programmed response, e.g.
synchronised braking of the drive system.
Stop!
Do not c onnect an external voltage to the state bus, otherwise the function
will be disturbed.
Electrical data
State bus
Rated voltage 24 V
According to IEC 61131-2
Switching level According to IEC 61131-2
LOW 0 V ... +5 V
HIGH +15 V ... +30 V
Looping through Max. 20 devices
DC-bus operation with
9300 devices is possible.
Connectable cross-cuttings See terminal data
Buy: www.ValinOnline.com | Phone 844-385-3099 | Email: CustomerService@valin.com
To Next Page
Loading...
