Lenze L−force GST - Mounting the Shrink Disc with a Rotating Cover

Mechanical installation
Mounting
Mounting the shrink disc with a rotating cover
4
l
29
BA 12.0023−EN 6.0
Dismounting
1. Undo axial gearbox locking in the hollow shaft.
2. Remove/extract the gearbox from the motor shaft using an appropriate auxiliary
tool (Fig. 6).
K12.0611
Fig. 6 Dismantling of gearboxes with hollow shaft using the auxiliary tool, not for GKR
Auxiliary tool (recommended dimensions)
Æ d
H7
c
8
c
9
25
30
10 3
35 12 3
40
45
16 4
50
55
16
20
5
60
70
20 5
80 20 6
100 24 8
Tab. 6 Dimensions in [mm]
4.4.7 Mounting the shrink disc with a rotating cover
( Stop!
Do not dismantle new shrink disc.
Never tighten clamping screws before the machine shaft is pushed in.
Otherwise the hollow shaft may be deformed plastically. Protect the shrink
disc against contact while in operation by appropriate measures (e.g. cover).
Degrease hollow shaft bore and machine shaft!