Lenze MSEMA Series - Handling

Handling
T
ransport, storage
Comply with the instrucons for transport, storage and proper handling. Ensure careful han-
dling and avoid mechanical overloading. Do not bend any components during transport and
handling and do not change the insulaon clearances. Do not touch any electronic compo-
nents and contacts. Do not damage or destroy any electrical components as doing so can
cause a health hazard!
The storage locaon must be free of vibraons and shocks (V
e
< 0.2 mm/s) in order to avoid
roller-bearing damage when equipment is at a standsll.
When the product is being stored, temperature changes with condensaon formaon are to
be avoided.
Shas and bright surfaces are delivered with protecon against corrosion.
Installaon
The technical data and supply condions can be obtained from the nameplate and the docu-
mentaon. They must be strictly observed.
You must install the product in accordance with the regulaons indicated in the associated
documentaon. Adhere to the climac condions as indicated in the technical data.
Ambient media − especially chemical aggressive media − can aack sha sealing rings and
paintwork (general plascs). Abrasive media can damage the sha sealing rings. If this hap-
pens, consult the responsible branch oce of Lenze.
Electrical connecon
When working on energised products, comply with the applicable naonal accident preven-
on regulaons.
The electrical installaon work must be carried out according to the appropriate regulaons
(e. g. cable cross-secons, fuses, PE connecon). Addional informaon can be obtained
from the documentaon.
The documentaon contains instrucons on EMC-compliant installaon. Comply with these
instrucons in the case of CE-labelled products as well. The manufacturer of the system or
machine is responsible for adherence to the limits required in connecon with EMC laws.
operaon
Where appropriate, you must equip the system/machine with addional monitoring and pro-
tecve devices. Comply with the safety regulaons and other regulaons applicable at the
place of operaon.
Aer the product has been separated from the supply voltage, refrain from immediately
touching the live parts and power connecons of the device because capacitors may have
been charged. Take note of the corresponding informaon plates on the product.
Deposited dirt or dust prevent head dissipaon (cooling). Remove any such deposits at regular
intervals.
Maintenance and servicing
The products are maintenance-free if the prescribed condions of use are complied with.
Disposal
The products and accessories must be properly disposed of in accordance with the applicable
regulaons. The products contain raw materials that can be recycled such as metals, plascs
and electronic components.
Project planning
Sa
fety instrucons
Handling
22