Lenze PROFIBUS-DP - Lenze Engineering tools; EASY Navigator

4 The Lenze automation system with PROFIBUS
4.3 Lenze Engineering tools
22
Lenze · Controller-based Automation · PROFIBUS® Communication Manual · DMS 4.6 EN · 11/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
4.3 Lenze Engineering tools
The Lenze Engineering tools enable the configuration and operation of controller-based Lenze
automation systems according to individual requirements.
Use the corresponding Engineering tool applicable to the field device.
»EASY Navigator«
The »EASY Navigator« provides an overview of the Lenze Engineering software installed on the
Engineering PC.
The Lenze Engineering software consists of the Engineering tools optimised for the respective
application case.
The »EASY Navigator« ...
• simplifies orientation for selecting the suitable Engineering tool;
• allows for the simple start of the required Engineering tool (depending on the application):
Further Engineering tools that are not called via the »EASY Navigator« are:
• »WebConfig« (web-based parameterisation, configuration, and online diagnostics)
•»IPC Backup & Restore« (data backup, data recovery).
What would you like to do? Button Engineering tool
Programming
• Parameterise the Lenze Controller
• Parameterisation of the i700 servo inverter
• Parameterise the I/O system 1000
»PLC Designer«
Inverter configuration
• Projecting the automation/drive system
• Parameterisation/configuration
• Inverter Drives 8400, 8400 motec/protec
• Servo Drives 9400
• I/O system 1000
»Engineer«
Visualisation
• Visualising the automation system
• Creating the user interface
»VisiWinNET«
Online diagnostics
Easy online diagnostics of Lenze Controllers and
other Lenze field devices
»EASY Starter«
Online parameterisation
• Online parameterisation and commissioning
• Direct online parameterisation when the online
connection to the Lenze devices is active.
»EASY Starter«