Lenze PROFIBUS-DP - Diagnostics in the PLC Designer

10 Diagnostics
10.3 Diagnostics in the »PLC Designer«
50
Lenze · Controller-based Automation · PROFIBUS® Communication Manual · DMS 4.6 EN · 11/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
10.3 Diagnostics in the »PLC Designer«
For the diagnostics of PROFIBUS, the »PLC Designer« provides the CAA_Device_Diagnosis.lib
function library.
 Note!
The diagnostics information in the CAA_Device_Diagnosis.lib function library is
currently only partly available. You can only execute a diagnostics process if the node
works without errors or if there is a fault. Currently, the PLC does not provide any
detailed fault information.