Lenze PROFIBUS-DP - Commissioning of PROFIBUS; Overview of the commissioning steps

6 Commissioning of PROFIBUS
6.1 Overview of the commissioning steps
26
Lenze · Controller-based Automation · PROFIBUS® Communication Manual · DMS 4.6 EN · 11/2016 · TD17
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
6 Commissioning of PROFIBUS
This chapter provides information on how to commission the Lenze automation system with
PROFIBUS.
Depending on the field devices used, the following Lenze Engineering tools
( 22) are required:
• »EASY Starter«
• »Engineer«
•»PLC Designer«
6.1 Overview of the commissioning steps
The main commissioning steps are listed in the following table:
 Note!
Via PROFIBUS, only Logic Field devices ( 20) can be operated.
Inverters which are to be controlled via the central Motion functionality must always be
connected via EtherCAT.
Mixed operation PROFIBUS with EtherCAT
( 43)
Step Activity Software to be used
1. Planning the bus topology
( 27)
2. Installing field devices
( 27)
3. Create a project folder
( 28)
4. Commission the field devices
( 28) »Engineer« / »EASY Starter«
5th Creating a PLC program with a target system (Logic/Motion)
( 29) »PLC Designer«
6. Configuring the communication parameters ( 31)
6. Importing missing devices / device description files
( 33)
7. Creating a control configuration (adding field devices)
( 34)
8. Configuration of the PROFIBUS master ( 38)
10. Configuring the PROFIBUS slave
( 41)
11. Compiling the PLC program code
( 42)
12. Logging in on the controller with the »PLC Designer«
( 42)
With the log-in, the fieldbus configuration and the PLC program are
loaded to the controller.
13. Starting the PLC program
( 42)