Lenze Smart Motor m300 - Safety Instructions; Basic Safety Instructions; Application as Directed

Safety instrucons
Disregarding the following basic safety measures and safety informaon may lead to severe personal injury
and damage to property!
Observe all specicaons of the corresponding documentaon supplied. This is the precondion for safe
and trouble-free operaon and for obtaining the product features specied.
Please observe the specic safety informaon in the other secons!
Basic safety instrucons
Personnel
The product must only be used by qualied personnel. IEC 60364 or CENELEC HD 384 dene the skills of
these persons:
•
They are familiar with installing, mounng, commissioning, and operang the product.
•
They have the corresponding qualicaons for their work.
•
They know and can apply all regulaons for the prevenon of accidents, direcves, and laws applicable at
the place of use.
Product
The product must never be technically modied!
If you carry out any technical modicaons or alteraons that are impermissible, all your warranty claims
will become void and the product liability will be excluded!
Process engineering
The procedural notes and circuit details described are only proposals. It is up to the user to check whether
they can be adapted to the parcular applicaons. Lenze does not take any responsibility for the suitability
of the procedures and circuit proposals described.
Applicaon as directed
•
The product must only be actuated under the operang condions and power limits specied in this
documentaon.
•
The product meets the protecon requirements of 2014/35/EU: Low-Voltage Direcve.
•
The product is not a machine in terms of 2006/42/EU: Machinery Direcve.
•
Commissioning or starng the operaon as directed of a machine with the product is not permied unl
it has been ensured that the machine meets the regulaons of the EC Direcve 2006/42/EU: Machinery
Direcve; observe EN 60204−1.
•
Commissioning or starng operaon as directed is only permissible if the EMC Direcve 2014/30/EU is
complied with.
•
The product is not a household appliance, but is only designed as a component for commercial or
professional use in terms of EN 61000−3−2.
•
The product can be used according to the technical data if drive systems have to comply with categories
according to EN 61800−3.
•
In residenal areas, the product may cause EMC interferences. The operator is responsible for taking
interference suppression measures.
•
Do not use the built-in brakes as fail-safe brakes. Disrupve factors that cannot be inuenced may cause
the braking torque to be reduced.
•
The product is a component designed for installaon into a machine for horizontal materials handling
technology.
Safety instrucons
Applicaon as directed
44