Lenze Smart Motor m300 - Page 62

Parameter set management
Parameter Value Comment
Designaon Delivery Seng range
PIN --- [0000 ... 9999] PIN for the protecon against unauthorised
alteraon of the parameter set (0 = no
protecon).
Alteraon of "PIN" sets "new PIN" to the
same value.
The parameters can also be read without a
PIN.
New PIN --- [0000 ... 9999] Future PIN for protecon against
unauthorised alteraon of the parameter set.
Standard sengs
Parameter Value Comment
Designaon Delivery Seng range
Parameter set name --- [Text] File name of the parameter set without le
extension *.lsm
Output speed 1 depending on the
order
[-2600/i ... -500/i] rpm
[0] rpm
[500/i ... 2600/i] rpm
CCW rotaon: < 0 rpm
STOP: 0 rpm
CW rotaon: > 0 rpm
Lenze Smart motor with gearbox: The rao i
is taken into account in the calculaon of the
output speed.
Output speed 2
Output speed 3
Output speed 4
Output speed 5
Acceleraon me [0.0 ... 20.0] s
n
max
t
Acceleraon me t
1
of the ramp generator
from 0 rpm to n
max
[2600/i] rpm
Deceleraon me Deceleraon me t
2
of the ramp generator
from n
max
[2600/i] rpm to 0 rpm
Energy-saving funcon [O] Opmized for:
•
High dynamic performance
•
Maximum starng torque and torque
•
High speed accuracy
[On] Reduced energy absorpon in paral load
operaonal range.
Approx. 50 % of the maximum starng torque
are available.
Diagnoscs
Parameter Value Comment
Designaon Delivery Seng range
Peak load of the drive --- [0 … 250] % Last peak value of the medium thermal load
(maximum value in the last mains switching
cycle)
From rmware version 03.00.00.00
Peak load of the brake
resistor
--- [0 … 250] % Last peak value of the thermal ulisaon of
the brake resistor (maximum value in the last
mains switching cycle)
From rmware version 03.00.00.00
Meters
Parameter Value Comment
Designaon Delivery Seng range
Elapsed-hour meter --- [0 ... 596523] h Total me of "Motor rotang"
Operang‐hour meter --- [0 ... 596523] h Total me of "mains ON"
Commissioning
62