Fel! Använd fliken Start om du vill tillämpa 見出し 1 för texten som ska visas här.
19
3-2 LOADING THE TUBES AND THE INK RIBBON CASE
1. Open the cassette cover.
2. Push the head release lever (green).
3. Slide the switching lever (silver) until it
stops.
4. a: Pass the tubes under the holding
plate.
b: Extrude the tip of the tubes
by 1～2cm from the machine.
5. Place and hold the tube on the “TUBE”
label and slide the “Switching lever” to
lock.
Pull out
Head release lever
Switching lever
1~2cm
To Next Page
Loading...
Need help?
General
