Fel! Använd fliken Start om du vill tillämpa 見出し 1 för texten som ska visas här.
35
Note: ● Only when the “AUTO” is selected to “OFF”, the size setting is available.
● The selectable “CHARACTER SIZE” varies depending on the size of the material, the
“PITCH LENGTH” and the number of lines, etc.
● When the “AUTO” is selected in the “CHARACTER SIZE”, the character sizes change
automatically, depending on the size of material, pitch length and the number of lines in
each block.
However, when the printed material is TAPE, “AUTO” cannot be selected in
“CHARACTER SIZE”.
6-2 WIDTH
Setting the “CHARACTER WIDTH” at the cursor position.
Note: You can select “CHARACTER WIDTH” according to the following table.
PRINTING
MODE
PRINTING
DIRECTION
STANDARD CONDENSED EXTENDED
Pitch print
(Tube)
Horizontal
Vertical
Pitch print
(Tape)
Horizontal
Vertical
Normal print
(Tape)
Horizontal
Vertical
Note: For “Vertical printing direction”, see “6-6: VERTICAL”.
1. Press WIDTH . The [CHARACTER WIDTH
setting screen] appears.
2. Press / key to select the “CHARACTER
WIDTH.”
3. Press ENTER .
Selectable items: STANDARD, CONDENSED, EXTENDED
▲ 2 0 .0 C U T 0 0 1
A B C
C H A R A C T E R W I D T H =
C O N D E N S E D