Connect the supplied power adapter to this jack.
After the device is powered on, press it to reset the device or restore to
factory default settings.
0-3 seconds: reset the device
6 seconds above: restore to factory default settings (this is used when
you can not login to the router, e.g. forgot the password)
Connect a UTP Ethernet cable (Cat-5 or Cat-5e) to the LAN ports
when connecting to a PC or an office/home network of 10Mbps or
100Mbps.
Connect the supplied USB cable to this port when connecting to the
PC
Connect the supplied RJ-11 (“telephone”) cable to this port when
connecting to the ADSL/telephone network.
To Next Page
Loading...
