IP Filter Rule Editing
IP Filter Rule Index: This is item number
Active: Select Yes from the drop down list box to enable IP filter rule.
Source IP Address: The source IP address or range of packets to be monitored.
Subnet Mask: It is the destination IP addresses based on above destination
subnet IP
Port Number: This Port or Port Ranges defines the port allowed to be used by
the Remote/WAN to connect to the application. Default is set from range 0 ~
65535. It is recommended that this option be configured by an advanced user.
Destination IP Address: This is the destination subnet IP address.
Subnet Mask: It is the destination IP addresses based on above destination
subnet IP
Port Number: This is the Port or Port Ranges that defines the application.
Protocol: It is the packet protocol type used by the application, select either TCP or
UDP or ICMP
Rule Unmatched: Select action for the traffic unmatching current rule; Forward to
leave it pass through, and NEXT to check it by the next rule.
IP Filter Listing
#: Item number.
Active: Whether the connection is currently active.
Src IP Mask: The source IP address or range of packets to be monitored.
Dest IP Mask: This is the destination subnet IP address.
Src port: This Port or Port Ranges defines the port allowed to be used by the
Remote/WAN to connect to the application. Default is set from range 0 ~ 65535. It is
recommended that this option be configured by an advanced user.
Dest Port: This is the Port or Port Ranges that defines the application.
Protocol: It is the packet protocol type used by the application, select either TCP or
UDP or ICMP
IP Filter Listing: Listing all IP Filter you’ve created.
To Next Page
Loading...
