LevelOne FCS-1041 - IP Address Configuration; PPPoE and Wireless LAN Setup

Network Camera User’s Manual
32/62
(1) “Get IP address automatically”
(2) “Use fixed IP address”
- “IP address”: This is necessary for network identification.
- “Subnet mask”: This is used to determine if the destination is in the same
subnet. The default value is ―255.255.255.0‖.
- “Default router”: This is a gateway used to forward frames to destinations
in a different subnet. Invalid router setting will fail the transmission to
destinations in different subnet.
- “Primary DNS”: The primary domain name server that translates
hostnames into IP addresses.
- “Secondary DNS”: Secondary domain name server backups the Primary
DNS.
- “Enable UPnP presentation & port forwarding”: Enable UPnP ability.
- “Http port” This can be typed besides the default Port 80. Once the port is
changed, the users must make sure the change for the connection is successful.
For instance, when the Administrator changes the HTTP port of the Network
Camera which IP address is 192.168.0.20 from 80 or 1025 to 65535, the users
must type in the web browser ―http://192.168.0.20:8080‖ instead of
―http://192.168.0.20‖.
- “RTSP Port” RTSP port can be typed besides the default Port 554
- “RTP Port” The RTP port can be typed besides the default Port 54
Note: Please set Video RTP port in even number after default value port 54. Then,
Video RTCP pot、Audio RTP port、Audio RTCP port will automatically set the
values in ascending.
- “RTSP Streaming access names” The RTSP streaming currently supports
video only, audio only, and audio/video. To use the audio/video stream, type the
URL as―rtsp://61.30.125.43/liveN.sdp‖.
2. PPPoE
If using the PPPoE interface, you should fill the following settings from ISP.
(1) “User name”: The login name of PPPoE account
(2) “Password”: The password of PPPoE account
(3) “Confirm password”: Input password again for confirmation
3. WIRELESS LAN (Wireless Model Only)
“SSID” (Service Set Identifier), it is to identify a wireless network. Access Points and
wireless clients attempting to connect to a specific WLAN (Wireless Local Area Network)
must use the same SSID. The default setting is default. Note: The maximum length of
SSID is 32 single-byte characters and SSID can’t be any of “, <, > and space character.
“Wireless mode” Click the down arrow to select one from options：
1. “Infrastructure” The Network Camera connects to the WLAN via an Access
Point. (The default setting)
(1) “TX rate” This field is for selecting the maximum transmission rate on the
network. The default setting is ―auto‖. It means the Network Camera will try to
connect to the other wireless device with highest transmitting rate.
(2) “Security” Select the data encrypt method