LevelOne FCS-1041 - Page 33

Network Camera User’s Manual
33/62
- “None” Do not use data encrypt.
- “WEP” allows communication only with other devices, which are with
identical WEP settings.
- “WPA-PSK” Use WPA pre-shared key.
- “WPA2-PSK” Use WPA2 pre-shared key.
(3) “Auth Mode” Choosing one of the following modes, (Default original setting is
OPEN).
- “Open” communicates the key across the network.
- “Shared” allows communication only with other devices, which are with
identical WEP settings.
(4) “Key length” The administrator can select the key length of 64 or 128 bits.
64bits is the default setting.
(5) “Key format” Choosing one of the following formats. ―HEX‖ is the default
setting.
- “HEX” digits consist of the numbers 0~9 and the letters A-F.
- “ASCII” is a code for representing English letters as numbers from 0-127
except ―, <, > and space characters that are reserved.
(6) “Network Key” Enter a key in either hexadecimal or ASCII format. When
selecting different key length, acceptable input length is listed as following:
64 bits key length: 10 Hex digits or 5 characters.
128 bites key length: 26 Hex digits or 13 characters.
Note: When 22(―), 3C(<) or 3E(>) are input in network key, the key format can’t be
changed to ASCII format.
(7) “Algorithm” Choosing one of the following algorithms for WPA-PSK modes:
- “TKIP”
- “AES”
(8) “Pre-shared Key” Enter a key in ASCII format. The length of the key is 8 ~ 63
2. “Ad-Hoc” Make the Network Camera connect directly to a host equipped with a
wireless adapter in a peer-to-peer environment.
(1) “Channel” Under infrastructure mode, the channel will be selected
automatically to match the channel setting for the selected Access Point. Under
Ad-Hoc mode, the channel must be manually set to the same channel for each
wireless adapter. The default channel setting depends on the installed region.
(2) “TX rate” This field is for selecting the maximum transmission rate on the
network. The default setting is ―auto‖. It means the Network Camera will try to
connect to the other wireless device with highest transmitting rate.
(3) “Security” Select the data encrypt method
- “None” Do not use data encrypt.
- “WEP” allows communication only with other devices, which are with
identical WEP settings.
(4) “Auth Mode” Choose one of the following modes, (Open is the default
setting).
- “Open” communicates the key across the network.
- “Shared” allows communication only with other devices, which are with
identical WEP settings.
(5) “Key length” The administrator can select the key length of 64 or 128 bits.
64bits is the default setting.