Network Camera User’s Manual
55/63
Maintenance
1. “Reboot system” The “Reboot” button will reboot the Network Camera. It’s useful
while the Network Camera got problem.
2. “Restore system” Click on ―Restore‖ button on the configuration page to restore
the factory default settings. Restore all settings to factory default except settings in
―Network type ‖ and ―Root Password‖. The system will restart and require the installer
program to set up the network again.
3. “Calibrate Camera”
-- “Home position” Recalibrate the home position to the default center to recover the
tolerance caused by some external forces. Please note that there is no confirming
message box after clicking on the ―Calibrate‖ button, the Network Camera will calibrate
immediately.
-- “Focus position”Recalibrate the autofocus position to the default range to recover
the tolerance caused by some external forces. Please note that there is no confirming
message box after clicking on the ―Calibrate‖ button, the Network Camera will calibrate
immediately.
To Next Page
Loading...
