Wireless LAN Access Point Connection
Chapter 2 Hardware Installation
1. Locate an optimum location for the Wireless LAN Access Point.
The best location for user’s Access Point is usually at the center of user’s wireless
network, with line of sight to all of user’s mobile stations.
2. Connect the Wireless LAN Access Point to user’s router, hub or switch.
Connect one end of standard UTP cable to the Access Point’s LAN Port and connect
the other end of the cable to a switch, a router or a hub. The Access Point will then be
connected to user’s existed wired LAN Network.
3. Connect the DC Power Adapter to the Wireless LAN Access Point’s Power
Socket. (WAP-0006)
Only use the power adapter supplied with the Access Point. Using a different adapter
may damage the product.
4. Connect the Wireless LAN Access Point to your POE adapter, router, hub or
switch. (WAP-0009 Only)
Connect one end of standard UTP cable to the Access Point’s LAN Port and connect
the other end of the cable to a powered Ethernet port on POE switch, POE router,
POE hub, or POE adapter. The Access Point will then power ON and connected to
your existed wired LAN Network.
The Hardware Installation is complete.
5
To Next Page
Loading...
