LevelOne WBR-6805 - MAC Address Cloning; Static IP WAN Configuration

38
MTU Size
To Enable the Maximum Transmission Unit of router setup. Any
packet over this number will be chopped up into suitable size
before sending. Larger number will enhance the transmission
performance.
Enter the MTU number in the blank to set the limitation.
Clone MAC Address
There are two ways to clone MAC address.
One way
is directory input MAC address in text box. Maybe you
need to save the MAC
Address, you can click 'Manual Add' button
and add it to “History MAC Table” for easily backup; another
is
click 'MAC Clone' button, then it will copy the MAC address from
your network card in the computer.
Note: The 'History MAC Table' can save maximum three MAC
Addresses.
History MAC Table
To Delete the MAC Address you add before, mark the check box
in the select item on the right hand and click the “Delete
Selected”. If you want to delete all the MAC Addresses, click
“Delete All” to remove all of them.
* Please click on the Apply Changes button or the Reset button at the bottom to save/reset the configurations.
1. Static Mode (fixed IP)
Items Information
Internet IP Address, Subnet
Mask and Default Gateway
Fill in the IP address, Subnet Mask and Default Gateway
that provided by your Internet Service Provider (ISP).
MTU Size
To Enable the Maximum Transmission Unit of router
setup. Any packet over this number will be chopped up
into suitable size before sending. Larger number will
enhance the transmission performance.
Enter the MTU number in the blank to set the limitation
(default 1500 bytes).