BEFORE INSTALLATION
INSTRUCTIONS PERTAINING TO THE RISK OF ELECTRIC SHOCK
2
CAT. NO. CIRCUIT BREAKER RATING
EVR40 50A
EVR30 40A
• Read all the instructions before using this product.
• This device should be supervised when used around children.
• DO NOT put fingers into the electric vehicle connector.
• DO NOT use this product if the flexible power cord or EV cable are frayed, have broken
insulation, or any other signs of damage.
• DO NOT use this product if the enclosure or the EV connector is broken, cracked, open, or
shows any other indication of damage.
• A device employing pressure terminal connectors for field wiring connections shall be
provided with instructions specifying a range of values or a nominal value of tightening torque
to be applied to the clamping screws of the terminal connectors.
CAUTION: To reduce the risk of fire, connect only to a circuit provided with below amperes maximum
branch circuit over-current protection in accordance with the National Electrical Code, ANSI/NFPA 70.
GROUNDING INSTRUCTIONS
The Charging Station must be connected to a grounded, metal, permanent wiring system; or an
equipment grounding conductor must be run with the circuit conductors and connected to the
equipment grounding terminal or lead on the product.
NOTE FROM THE MANUFACTURER
This document provides instructions for the Evr-Green
®
series Charging Stations and should not
be used for any other product. Before installation or use of this product, you should review this
manual carefully and consult with a licensed contractor, licensed electrician, or trained installation
expert to make sure of compliance with local building codes and safety standards.
www.leviton.com/evrgreen
To Next Page
Loading...
