Levo COMP ALLOY User Manual

37
-1°
+1°
12.6
Fig. 12.6
When aligning the headset cup, the etching that is at the front of the bicycle indicates which
setting you are in.
Make sure the head tube and headset cup are free of dirt and debris when
changing the upper cup angle. Lubricate all the parts with high-quality
waterproof grease.
All models are assembled with the zero offset headset cup. Switching the
headset cup steepens or slackens the head tube angle by +/-1 degree.
The bottom headset cup is used for all options of adjustability, the cup has
a spherical interface with the head tube and will move with the angle of the
steerer tube.
D
C
D
A
B
12.7
FORK
Fig. 12.7
 Slide the fork steerer tube back through the head tube and headset parts (A).
 Install the stem onto the steerer tube (B).
 Install the top cap and compression bolt into the star nut in the fork (C). Tighten the bolt
until all the parts are snug and settled. The stem should rotate freely, but there should be no
fore/aft free play in the system.
 Pull front brake and rock the bicycle back-and-forth a few times with the stem bolts
loosened to make sure everything is well seated
 If necessary re-tighten the headset top cap (C).
 Torque the stem bolts to the recommended torque setting.

Levo COMP ALLOY Specifications

General

Battery	Levo 700Wh
Fork	RockShox 35 Gold RL, 150mm
Drivetrain	SRAM
Tires	Butcher, 29x2.6"
Display	TCU
Charger	Specialized 4A
Shifters	SRAM SX Eagle, 12-speed
Rear Derailleur	SRAM SX Eagle, 12-speed
Cassette	SRAM PG-1210, 11-50t
Chain	SRAM SX Eagle, 12-speed
Chainrings	32t
Handlebars	Specialized Trail, 780mm
Stem	Specialized Trail, 50mm
Seatpost	Specialized, 30.9mm
Rims	Specialized 29, 30mm inner width
Front Hub	Specialized, sealed cartridge bearings
Rear Hub	Specialized, sealed cartridge bearings
Front Tire	Butcher, 29x2.6"
Rotors	200mm
Hubs	Specialized, sealed cartridge bearings
Bottom Bracket	SRAM DUB
Grips	Specialized Sip Grip
Headset	1-1/8" upper, 1.5" lower
Rear Tire	29x2.6"