Levoit EverestAir LAP-EL551S-AUS - Controls & Display Functions; On;Off, Display, and Mode Buttons; Air Quality Indicators

6
CONTROLS & DISPLAY
On/O Button
• Turns the air purifier on/o.
• Press and hold for 5
seconds to connect the air
purifier to the VeSync app.
See the in-app instructions
for more information.
• Press and hold for 15
seconds to reset the air
purifier and disconnect from
Wi-Fi (see page 9).
Air Info Button
• Changes the type of air
quality information shown
on the center of the display.
• Cycles through air quality
readings for PM1.0, PM2.5,
PM10, and overall clean
air percentage (see Air
Information, page 11).
• The chosen air quality
information will stay on the
display until you restart the
air purifier.
Filter Info Button
• Shows the filter life
percentage on the center
of the display. After a few
moments, the display
will return to its previous
setting.
• Button lights up when the
filter should be checked
(see Check Filter Indicator,
page 17).
• Press and hold for 3
seconds to reset the
indicator (see page 17).
Display
• Shows information related
to air quality and air purifier
settings.
• By default, the display will
show the overall clean air
percentage.
• The display will reset to
default when the air purifier
is turned on/o.
Sleep Mode Button
• Turns Sleep Mode on/o
(see page 10).
Auto Mode Button
• Turns Auto Mode on/o
(see page 10).
Turbo Mode Button
• Turns Turbo Mode on/o
(see page 10).
Air Quality Indicator Rings
• These indicators use an
automatic sensor to display
the air quality: Blue (Very
Good), Green (Good),
Orange (Moderate), and
Red (Bad).
Note: You can also use the VeSync app to control these functions, as well as additional app-only features
(see page 9).