GETTING STARTED
1. Remove all packaging.
2. Take the water tank o of the base and
remove all tape, including any tape on
the float. Figure 1.1
Figure 1.3
Figure 1.1
Figure 1.4
Figure 1.5
Figure 1.2
3. Rinse and reassemble all parts before
first use (see Cleaning, page 15).
Note:
• Check to make sure that the water filter
is correctly in place. If not, then rotate
the filter clockwise to secure it in place.
Figure 1.2
4. Choose a hard, flat location for the
humidifier at least 30 cm / 12 inches
away from any walls. The surface
must be water-resistant. Figure 1.4
5. Mist should be directed away
from walls, furniture, bedding, and
appliances. Figure 1.5
• Check to make sure that the float is
securely in place. Figure 1.3
30 cm /
12 in
30 cm /
12 in
EN
9
To Next Page
Loading...
Need help?
General
