7
GETTING STARTED
1. Remove the filter cover. Pull the filter
from the housing. [Figure 1.1]
2. Take the filter out of its plastic
packaging, then reinstall it into the
housing. Make sure the pull tabs on the
filter are facing out. [Figure 1.2]
3. Replace the filter cover by lining up the
cover’s feet with the slots in the bottom
of the housing. [Figure 1.3]
4. Push the cover securely closed.
[Figure 1.4]
Note:
• If you are not planning to use the air
purier for a long period of time, keep
the lter clean by leaving it inside its
plastic packaging until it is ready to be
used.
Figure 1.1
Figure 1.4
Figure 1.2
Figure 1.3
To Next Page
Loading...
