8
Figure 2.1
Figure 2.2
USING YOUR AIR PURIFIER
1. Place the air purifier on a level surface.
[Figure 2.1] Leave 15 in / 38 cm of
clearance on all sides of the purifier.
[Figure 2.2]
2. Plug in. Tap to turn on the air
purifier. The fan will start automatically.
3. Optionally, tap to change the fan
speed. You can also select Auto Mode
or Sleep Mode, or set a timer.
a. For best results, or to address a
specific air quality issue such as
smoke, run the air purifier at high
speed for 15–20 minutes before
using a lower speed or Auto Mode.
b. To eectively clean air, keep
windows and doors closed while
the air purifier is on.
4. Tap to turn o the air purifier.
Auto Mode adjusts the fan speed
automatically based on air quality. For
example, if the air quality is bad, the fan will
be set to high speed.
• Tap to turn Auto Mode on/o.
• Tapping or will also exit Auto
Mode.
General Operation
Auto Mode
15 in /
38 cm
Air Quality Indicator Chart
Indicator
Color
Air Quality Fan Speed
Blue Very Good Sleep Mode
Green Good Low
Orange Moderate Medium
Red Bad High
This indicator uses an automatic sensor to
display the air quality. This sensor uses an
infrared light to detect airborne particles
The air purifier will take 30 seconds to
detect the air quality each time it is turned
on. During this time, the air quality indicator
color will be blue. After 30 seconds, the air
quality indicator color will change based on
the detected air quality.
Air Quality Indicator